Dark WL I PIR LED Solar
MODEL: 44083
INTRODUCTION
The Light works with a build-in PIR (Passive Infra Red) sensing device
which is connuously scanning for heat-source moving in its detec-
on scope. Once a heat-source (such as a human or a car) is detected
in that area, the light switches on immediately and automacally to
illuminate your pathways, steps, paos, porches, or anywhere you
select for safety, convenience or security. The light remains on while
heat-source moving stays in the detecng scope.
INSTALLATION SUGGESTIONS
For best detecng effect of PIR, we suggest you take the following
points into account:
Ideally, for maximum detecon range, the Light should be moun -
ted 1.8 to 2.5 meters (6 to 8 ) above the area to be scanned
(refer to Fig.1A).
To avoid damage to some components, please do not aim the
sensor towards the sun.
To avoid annoying unexpected triggering, the sensor should stay
away from heat sources such as barbecues, Air-condioners, other
outside lighng, moving cars and flue vents.
To avoid annoying unexpected triggering, please keep the sensor
away from strong electromagnec disturbance source.
Do not aim the sensor at reflecve surfaces such as smooth white
walls, swimming pools, etc...
The PIR sensor’s detecon range (about 7 meters at 100°round)
may vary slightly depending on the mounng height and locaon.
The detecon range may also alter with environment temperature
change.
Before select a place to install, please note that sensor is more
sensive to movement across the scan area than to movement
directly toward or away from the sensor (refer Fig.1B). If heat
Side View
Front View
100°
4.5 M
0.7 M
7 M
2 M
Fig 1( A )
Detection Range
153 mm
157 mm
109 mm