Gebruikershandleiding Extron Electronic Kabeldoos 200 [11/18 Pagina's]

Extron electronic kabeldoos 200

Cable Cubby 200 • Installation 6

1. Prepare the Routing Template

NOTE: Save and reuse the metal routing

template for installing additional Cable

Cubby 200 models.

a. Cut 1/2 inch x 4 inch strips of soft, finished

lumber to a length that is long enough to span

the edges of the mounting surface.

b. Place the template over the strips so that the

opening reaches the desired mounting location

and the strips span the surface.

c. Using at least four mounting screws, secure the

mounting template to the lumber so that the

cut-out coincides with the desired orientation of

the enclosure.

ATTENTION: Potential damage to

property. Protruding screws

will scratch the table.

2. Prepare the Table with a Router

a. Mark the desired mounting location on the

tabletop. Ensure the enclosure will face the

desired direction.

b. Place the mounting template assembly on the

mounting surface with the lumber strips against

the table surface and centered on the marked

location. If necessary, use a square to ensure

that the template is properly positioned. Extron

is not responsible for improperly positioned

Cable Cubby models.

c. Secure the assembly to the table with

C-clamps. Use an additional lumber strip

underneath the tabletop to buffer it from the

C-clamps.

Preparing the Table

Extron recommends cutting the hole in the table with the Extron metal routing template (see

“Routing Template Part Numbers” on page 11 for part numbers).

NOTE: The hole can be also cut with a CNC wood router or a paper cut-out template

(available on the Extron website, www.extron.com), but these methods are not

recommended.

ATTENTION: Potential damage to property.

• Exercise care to prevent scarring or damaging the furniture.

• The opening in the table should be cut only by licensed and bonded

craftspeople.

• The routing templates for various Cable Cubby models are not

interchangeable. Using the wrong template will produce an improper ﬁt.

1/2” x 4” Soft, Finished

Lumber

Width of Mounting Surface

CABLE CUBBY 200

USER ACCESS

4 Screws Min.

Routing Area

1/2” x 4” Soft, Finished

Lumber

Clamps (4)

Sandwich Table

Between Soft Lumber

CABLE CUBBY 200

USER ACCESS

Routing Template

handleidingenoceaan.nl

Info

Extron Electronic kabeldoos SDI-AVR 100

Extron Electronic kabeldoos HDSDI-ACR 100

Extron Electronic kabeldoos TP R AV

Extron Electronic kabeldoos 60-161-01

Extron Electronic kabeldoos TP R BNC A

Extron Electronic kabeldoos VSC 700

Extron Electronic kabeldoos VSC 500

Extron Electronic kabeldoos VSC 700D

handleidingenoceaan.nl

Info