Gebruikershandleiding Garmin Computerscherm 100 [12/49 Pagina's]

Garmin computerscherm 100

Installation

Mounting the Transducer

Trolling Motor Installation

Included in the 010-10251-00 transducer kit you should have:

1. Worm Gear Clamp

2. Cable Ties

3. Transducer

Mounting the Transducer:

1. Loosen the Worm Gear Clamp until end of the band is clear of the worm

gear.

2. Slide the clamp band through the slots on the transducer.

3. Place the free end of the clamp band into the worm gear and tighten

until the band is through the worm gear.

4. Place the clamp and transducer over the body of the trolling motor.

Finish tightening the clamp to secure the transducer to the trolling

motor.

5. Secure the transducer cable to the trolling motor shaft using the

supplied cable ties.

Slide clamp band through slots on transducer

Clamp Band

Cable Ties

Worm Gear

If you are experiencing interference while the trolling motor is

operating, try installing the transducer cable at right angles to the

trolling motor power cables.